Trailer wiring, accessory installs and clean routing, done so it works and stays out of sight.
A good wiring job is hard to photograph, because there is not much to see when it is done. Trailer wiring shows why it matters. A flat four-pin plug carries running lights, left and right turn signals, and a ground. A seven-way adds reverse, 12 volt power and the electric brake signal, so it has to be planned for more than a simple light circuit. The plug on the truck and the plug on the trailer have to agree, and the ground has to be solid at both ends. Get that right and everything behind you works every time you hook up.
When trailer lights act strange, the ground is the first place to look. One dim turn signal, lights that flash together, or a brake light that comes on with the blinker usually means a ground that has corroded or come loose, not a bad bulb. Accessories go wrong in a different way. Tap the wrong wire on a newer vehicle and you can feed something you never meant to touch, or leave a circuit live that drains the battery while the truck sits. Wire run across a sharp edge or near the exhaust will eventually rub through or cook.
Clean routing means the wire follows protected paths, stays tied up off moving parts and heat, and only passes through metal with a grommet or loom around it. Every added circuit should have its own fuse close to the power source. Before you come in, write down what you want added and whether anything on the vehicle already acts up, and tell us about wiring anybody else has done. Alarms, stereos, lights and other accessories tend to share the same few power points, so knowing what is already back there keeps the new work from stepping on the old.
Most of the time it is a ground or a corroded connector, not the lights. A plug that works when you wiggle it is telling you the same thing. Checking the connection at both the truck and the trailer is the place to start.
If the problem is with trailer lights, yes. Having both ends in the same place lets the plug on the truck and the wiring on the trailer get checked together, so nobody is guessing which side is at fault.
It helps a lot to know. Older add-ons often share the same power points a new accessory would use. Tell us what has been added and we will look at it before tying anything new in.
We are open 7 days a week, from 7 AM to 10 PM.
No. Walk-ins are welcome, and you can also book ahead with the form on this page or call (270) 234-6030.
Yes. Estimates are free, so stop by or give us a call and tell us what you have in mind.
We are at 541 Kirkpatrick Avenue in Hodgenville, KY 42748, serving LaRue County.
Drop your info and we'll text you back to lock it in. Walk-ins + appointments welcome. Or just call (270) 234-6030.